Illustrative image – not actual.Tata
Sponge Iron has plans to increase its sponge iron manufacturing capacity from
the present 2.4 lakh tonnes per annum (tpa) to 3.9 lakh tpa.
This
would be achieved by installing a new kiln – its third – with a capacity of 1.5
lakh tpa, costing Rs.67 crore. The project cost would also cover complementary
facilities like raw material circuit, crushing station and a railway siding.
The project that would be funded largely through internal accruals will have a
gestation period of two years.
Power
required for the third kiln would be sourced from the company’s existing 7.5 MW
captive power plant. The power plant runs of waste heat generated from Kiln
No.2
The
kiln will most probably be set up with technical expertise from Tata Iron &
Steel Co, its holding company. Lurgi of Germany is also likely to be one of the
technology suppliers.
Meanwhile,
the company is negotiating with the electricity boards of Orissa and
neighbouring Jharkhand to sell power based on “waste heat” emanating from its
two kilns. If the company finds remunerative prices for its power, it would weigh
the option of setting up two power plants at its existing Kiln No.1 and the
proposed Kiln No.3. Accordingly a 7.5 MW plant costing Rs.27 crore and a 10 MW
plant costing Rs.40 crore might be set up. These plants would be attached to
Kiln No.1 and Kiln No.3, respectively.
Sponge
iron is an important raw material for the manufacture of steel, and is obtained
through direct reduction of iron. Sponge iron is also referred to direct
reduction iron or directly reduced iron (DRI). India has, in recent years,
emerged as the world’s largest sponge iron producer ousting former leader
Mexico. India produced 5.44 million tonnes of sponge iron in 2001-02 against
5.43 million tonnes in 2000-01, and 5.32 million tonnes in 1999-00. During the
first ten months of 2002-03, production was 5.12 million tonnes. India accounts
for one eighth of world sponge iron production.
