Essar Steel to take BF route in Phase II expansionIllustrative image – not actual.

Essar Steel has reportedly decided to use the blast furnace route for its future expansion round at the Hazira steel complex in Gujarat. The company has firmed up its plans to install a blast furnace of 0.83 million tpa taking its total steel capacity to 5.43 million tpa.

The decision has been prompted by lower availability of gas which has affected power production and ultimately the electric arc furnaces in operation. For the blast furnace, the company would use imported coking coal. This coal would be converted into metallurgical coke by a proposed 5 lakh tpa coke oven battery costing Rs.145 crore.

The shift from the EAF to the BF route would bring about similarity with other integrated steel producers -- SAIL, Tata Steel, JSW Steel, Ispat, RINL, etc.

The company is also in the midst of adding two hot briquetted iron (HBI) lines, as part of taking steel capacity to 4.6 million tpa. [HBI is derived from direct reduction iron (DRI or sponge iron)].

Note: In 2004-05, the company embarked on an expansion drive aiming at finished steel capacity of 4.6 million tpa from the existing 2.4 million tpa. This was to be achieved by de-bottlenecking the three existing electric arc furnaces from 0.8 million tpa to 1.2 million tpa each, and adding a fourth EAF of 1 million tpa. By mid-2005, Essar Steel had attained capacity of 3 million tpa of finished steel. The fourth EAF project is in the planning stage. The full capacity of 4.6 million tpa is scheduled to go on stream by September 2006. Power required for the expanded steel capacity would come through a under-construction 350 MW gas-based captive power plant, scheduled to commission by September 2006. Currently, power is being supplied by Essar Power that has a 515 MW power plant at Hazira. The steel complex uses power worth 215 MW, while 300 MW is being sold to the Gujarat Electricity Board.

Essar Steel is India's largest sponge iron producer with capacity 3.4 million tpa. This sponge iron is converted into HBI, which in turn is used to make steel through the EAF route.

← All latest storiesBack to top →